This feature is currently only available for our Facade Management product
From the map view, select Create an Observation
You will be taken to the Create Observation Page.
Mark the area of the defect by clicking and dragging your mouse from the top-left corner to the bottom-right corner. An orange rectangle will appear denoting the observation location. You can adjust its size by dragging the grips at its corners.
Optional: You can also add a length or area measurement to calculate the size of the repair.
Measure Area: Click and drag from the top-left to bottom right corner of the area that you estimate will need to be replaced to correct the defect. A blue rectangle will appear denoting the repair location. You can adjust its size by dragging the grips at its corners.
Measure Length: Click on one end of the repair and then the other to mark the length that will need to be repaced to correct the defect. A blue line will appear denoting the repair length. You can adjust its length by dragging the grips at its ends.
You will then need to specify the:
- Level
- Classification
- Trade
- Element
- Observation Type
from the drop-downs on the left-hand side of the page.
If you can't find the precise trade, element, or observation you are looking for, please message us via our help chat.
You can also add up to 2 additional images you wish to appear as a part of the observation.
Upon clicking Create Observation you will be shown a success notification and you can review your newly created observation on the Map View.
Please note: When returning to the map view, the created observation may not appear if you have active filters that exclude it. In this case please adjust your filters accordingly to view your observation.